How long should my Western girth be?

Sizing. Western cinches are typically sized in 2-inch increments, between 26 and 34 inches. To measure, place an unrigged saddle on your horse’s back. With the help of a friend, place a soft measuring tape beneath the girth area to measure between the saddle’s dee rings.

How should a Western girth fit?

The girth shouldn’t feel too tight, but tight enough that the saddle won’t shift while riding. When checking, make sure there’s enough space to fit three to four fingers between the girth and your horse.

How do I choose the right girth?

The size of your girth will depend on two main factors: the type of saddle and the stomach width of your horse. If you own a dressage saddle, your girth straps will typically lie much lower down against the horses side and so will require a shorter length girth.

Where should the girth sit on a horse?

A correctly fastened girth should rest approximately one hand’s width behind the horse’s elbows.

What size is Western girth?

Horse HeightWesternEnglish
14H to 15H (Small Horse)30-3242-44
15H TO 16H (Medium Horse)32-3446-48
16H to 17H (Large Horse)3650-52
17H and Over54-56

Do you measure a Western girth from buckle to buckle?

Girths should be measured from buckle end to buckle end. Make sure the buckle’s tongue flushes with the buckle, then, using a tape measure, measure until you find one that matches your horse.

What’s the difference between a cinch and girth?

What’s the difference between a girth and a cinch? A girth is used for English riding, whereas a cinch is used for Western. Structure-wise, they’re similar but not identical. A girth has two buckles on each end that fasten to the billets (i.e. girth straps) under the saddle flap.

How should a Monoflap girth fit?

What is the ideal girth length? For dressage/monoflap jump girths we recommend the girth be 4-6 inches from the bottom of the saddle flap. This will keep the buckles above the elbow, allow for greater pressure distribution, and prevent the edge of the girth from resting on the horse’s pectoral muscles.

How tight should your horses girth be?

The girth should be tight enough to keep the saddle in position but not so tight that it interferes with your horse’s movement or causes the saddle to slip forward. To check if the girth is tight enough, try this test: when you’re riding, pay attention to how your horse is moving.

How do I measure my girth?

How to Measure Girth, AVERAGE GIRTH SIZE and What it Looks Like

Is a cinch and girth the same thing?

A girth, sometimes called a cinch (Western riding), is a piece of equipment used to keep the saddle in place on a horse or other animal. It passes under the barrel of the equine, usually attached to the saddle on both sides by two or three leather straps called billets.

Why does my western saddle slide back?

Saddle fit and girth type are likely to be the main causes for your saddle sliding back when riding. It is more likely the saddle is too wide rather than too narrow for it to slide back.

What size saddle do I need for a 16 hand horse?

Under 16.5 inches — You probably need a 15-inch seat size in an English saddle. Between 16.5 and 18.5 inches — Look for a 16-inch saddle. Between 20 and 21.5 inches — Try a 17-inch saddle. Over 21.5 inches — Try an 18- or 19-inch seat size.

How do I know what size Western girth to buy?

Take the heart girth measurement (in inches) and divide it by 2. Then subtract 3 from your answer. If your figure isn’t a whole number, round it up. This should give you an estimate for your horse’s cinch size.

How tight should a saddle be?

You should be able to put one index finger under the cinch to your finger’s first joint. If you can reach in at the back of the cinch more than that, it’s probably too loose. If you can’t fit a finger in at all, it may be too tight.

What length girth do I need?

Horse HeightLong GirthShort Girth
13H to 14H38 – 4018 – 20
14H to 15H42 – 4422 – 24
15H to 16H46 – 4826
16H to 17H50 – 5228

Why are dressage girths shorter?

Short girths are designed for saddles with long billets. Most dressage riders prefer a short girth because it keeps the area underneath the thighs and/or knees bulk-free. The downside is that the buckles are located farther down, directly on the horse’s body.

What’s the average size cinch for a horse?

Most horses are a 24-26″ cinch, no matter what their height is. Some signs that your cinch may be too long include your horse being cinchy and even turning to bite you when your are cinching up. It is uncomfortable to them and they know it is going to cause them irritation so they try to give you warning signs.

Why does a saddle have 3 girth straps?

The 1st & 4th girthing can sometimes help with lateral stability on rounder horses. The 1st & & 3rd girthing options are sometimes good for ponies and horses with no withers and high Spring ribs, these can help prevent a saddle slipping forwards.

How do you measure a Western saddle girth?

How to measure your horse for a western cinch – YouTube


Videos

How to Measure a Girth or Cinch

How to Measure and Fit for a Dressage Girth

Quick Tip: Western stirrup length


Other Articles

What do horse riders wear on their legs?

How did Alexander ride the horse?

Are breeches comfortable?

What do shims do on saddle?

How do you tell if your saddle is hurting your horse?